Manufacturer: RigExpert Ukraine
Warranty: 2 years
The analyzer is designed for measuring SWR (standing wave ratio), return loss, cable loss, as well as other parameters of cable and antenna systems in the range of 100 kHz to 2000 MHz. A built-in ZOOM capability makes graphical measurements especially effective. An integrated Time Domain Reflectometer mode can be used to locate a fault within the feedline system. The analyzer is equipped with a Bluetooth Low Energy module for a wireless connection with your laptop, tablet or smartphone.
The following tasks are easily accomplished by using this analyzer:
• Rapid check-out of an antenna
• Tuning an antenna to resonance
• Comparing characteristics of an antenna before and after specific event (rain, hurricane, etc.)
• Making coaxial stubs or measuring their parameters
• Cable testing and fault location, measuring cable loss and characteristic impedance
• Measuring capacitance or inductance of reactive loads
Warranty coverage by the RigExpertCare™
Frequency range: 0.1 to 2000 MHz
Frequency entry: 1 kHz resolution
Measurement for: 25, 50, 75, 100, 150, 200, 300, 450 and 600-Ohms systems
SWR measurement range: 1 to 100 in numerical mode, 1 to 10 in graph mode
R and X range: 0…2000, -2000…2000
SWR, return loss, R, X, Z, L, C, Magnitude, and Phase Angle at a single frequency, SWR chart (100 points). SWR chart at fixed HAM bands by IARU Regions (100 points), Multé mode, Cable tools (Velocity factor measures, Cable length measurer, Stub tuner, Cable loss check), TDR
Optional open-short-load calibration in SWR, R, X, or Smith/polar chart graph modes.
Dimensions: 23x10x5.5 cm (9x4x2”)
Operating temperature: 0…40 °C (32…104 °F)
Weight: 650g (23 Oz)
Warranty: 2 years
RigExpert AA-2000 ZOOM is made in Ukraine.
Specifications are subject to change without notice.
|Function||AA-35 ZOOM||AA-55 ZOOM||Stick 230||Stick Pro||AA-230 ZOOM||AA-600||AA-650 ZOOM||AA-1000||AA-1400||AA-1500 ZOOM||AA-2000 ZOOM|
|Frequency range||0.06-35 MHz||0.06-55 MHz||0.1-230 MHz||0.1-600 MHz||0.1-230 MHz||0.1-600 MH||0.1-650 MHz||0.1-1000 MHz||0.1-1400 MHz||0.1-1500 MHz||0.1-2000 MHz|
|Frequency entry step size||1 kHz|
|Min. sweep range||10 kHz||1 kHz||10 kHz||1 kHz||10 kHz||1 kHz|
|Reactance sign measurement||+|
|Antenna connector type||UHF (SO-239)||type N|
|Output power||+13 dBm||-10 dBm|
|Output amplifier||CMOS logic chip|
|Output signal shape||square|
|Reference impedance for SWR measurement||50, 75 Ohm||25, 50, 75, 100, 150, 200, 300, 450, 600 Ohm||12.5, 25, 28, 37, 50, 75, 100, 150,
200, 300, 450, 600 Ohm
|25, 50, 75, 100, 150, 200, 300, 450, 600 Ohm||50, 75 Ohm||25, 50, 75, 100 Ohm||25, 50, 75, 100, 150, 200, 300, 450, 600 Ohm||25, 50, 75, 100 Ohm||25, 50, 75, 100, 150, 200, 300, 450, 600 Ohm|
|Battery voltage sensor||+|
|Operation with external power supply (without battery)||from USB|
|LCD||Color TFT 320×240||200×200 monochrome e-paper display||200×200 color TFT display||Color TFT, 290×220||Color TFT, 320×240||400×800 BlanView display|
|Time Domain Reflectometer mode||– *||Built-in||– *||Built-in|
|Flash memory for storing graphs||–||10 memory slots||–||90 R/X or SWR memory slots, 10 TDR memory slots||10 memory slots||90 R/X or SWR memory slots, 10 TDR memory slots|
|Multilingual support||English only||+||English only||+|
|Presets for radio amateur bands||–||+|
|AA-35 ZOOM||AA-55 ZOOM||Stick 230||Stick Pro||AA-230 ZOOM||AA-600||AA-650 ZOOM||AA-1000||AA-1400||AA-1500 ZOOM||AA-2000 ZOOM|
Make sure the latest firmware is uploaded to the analyzer.
* The AntScope software is able to plot graphs in Time Domain Reflectometer (TDR) mode when AA-30/AA-54/AA-170 is connected to the computer. Since the resolution of the TDR graph is proportional to the maximum operating frequency of an analyzer, much better results are obtained by using AA-230 ZOOM, AA-600, AA-1000 or AA-1400.
The device which has stopped functioning due to factory defects within the Warranty period will be replaced by a new one in a very few days instead of waiting when it’d be fixed. Just contact the RigExpertCare™ partner to get such a great support!
RigExpertCare™ is the 2-years limited warranty coverage for RigExpert™ products.
RigExpertCare™ means that the Rig Expert Ukraine will replace defective goods covered by the Warranty with the new goods of the same model as soon as possible.
The warranty is non-transferable. Only the original customer is covered under the RigExpertCare™ warranty.
In rare cases, when warranty repair is required, the RigExpertCare™ partner may require confirmation of an official purchase (for example, purchase receipt etc.)
The warranty does not apply to a product which has been damaged due to accident, misuse, abuse, improper installation, usage not in accordance with product specifications and instructions, natural or personal disaster, or unauthorized alterations, repairs or modifications.
The warranty does not cover any events including but not limited to:
Customers are responsible for shipping costs to ship back the defective item for RMA repair/replace.
Once the faulty item is received by RigExpertCare™ partner a new replaced item will be shipped back to the customer.
Shipping methods will be at Rig Expert’s discretion.
Therefore, RigExpertCare™ partner reserves the rights to ship according to what it deems the most efficient standard method of shipping.
Rig Expert Ukraine Ltd. can repair defective goods at the Customer’s request. To get a warranty repair please contact your original seller.
RF SOLUTIONS has decided to refine our product range, and would like to inform you that effective as of Friday, 12 July 2019 we no longer carry ICOM products.